A Digital and Analog Design Engineer with over 10+ years’ experience in hardware and firmware design for control and communications systems. Expertise includes:
Board-level digital and analog, digital ASIC front end, and FPGA design.
Embedded microprocessors and DSP applications, buses and interfaces.
10+ years of experience in technical leadership and development of innovative analog, mixed-signal, and power management ICs.
Design experience in Bipolar, CMOS, BiCMOS, High-Voltage BCD, LDMOS.
Experience in design of switching regulator systems and a variety of custom analog circuits towards power management products, Programmable Rotary Encoder, and high-speed communications products.
Experience with high performance voltage and current mode switching DC/DC converters and controllers, LDOs, LED drivers, linear voltage regulators, bandgap references including ultra-low power bandgaps, effective bias circuits, protection circuits, A/D-D/A data converters, precision amplifiers and comparators, oscillators, PLLs, VCOs, High Speed Custom Digital circuits and IOs, various sensors, and others.
Bob – Analog Mixed Signal Design/Verification Engineer
Design of Analog blocks for capacitive touch circuits.
Analog-Mixed signal verification at chip level.
Write, debug, and run test benches using Verilog-A/Verilog-AMS/System Verilog to verify both models and transistor-level circuits at all operating modes using the AMS-Designer environment.
Design functional models for Buck, Boost, LDO, Load Switch, RCO, Rectifiers, Analog comparators, PLL, ADCs in Verilog-AMS/DMS.
